Printing problems – HP 8700 User Manual
Page 54
Solution
The printer may make noises after long periods of inactivity
(approximately 2 weeks) or when its power supply has been interrupted and then
restored. This is normal operation. The printer is performing an automatic
maintenance procedure to ensure it produces the best quality output.
Printing problems
Note
Before contacting HP Customer Care, read this section for
troubleshooting tips or go to the online support services at
name of HP’s support services may vary by country/region.
The printer does not print borderless photos when I print from the control panel
Solution
Press the
Layout
button until
Layout: 1 photo borderless
appears,
then try to print again.
Printing is very slow
Cause
You may be printing a PDF or a project containing high-resolution
graphics or photos. Large, complex projects containing graphics or photos print
slower than text documents.
Solution
Consider using lower resolution graphics in the project, if possible, or
allow for longer print times in your workflow.
Cause
The printer may be in Ink-Backup Printing Mode. The printer enters this
mode when one of the print cartridges has been removed or is out of ink.
Solution
Replace the missing or empty cartridge.
Paper does not feed into the printer correctly from the Main tray
Solution
●
There may be too much paper loaded in the tray. Remove some paper and
try printing again.
●
The paper guides may not be adjusted correctly. Make sure the paper-width
and paper-length guides fit close to the edges of the paper without bending
the paper.
●
Two or more pieces of paper may be sticking together. Remove the paper
from the Main tray, fan the edges of the stack to separate the sheets of
paper, then reload the paper and try printing again.
●
If the paper is wrinkled or bent, try using different paper.
●
The paper may be too thin or too thick. Use HP inkjet paper for best results.
For more information, see
.
Printed pages are dropping off of the Out tray
Chapter 8
50
HP Photosmart 8700 series