HP 8700 User Manual
Page 16
Paper type
How to load
Tray to load
Any supported
photo or plain
paper media
1.
Raise the Out tray (4).
2.
Load paper print-side
down. Press the Main tray
release (2) and pull out
the tray if needed for
easier access. Check that
the stack of paper is no
higher than the top of the
paper-length guide (3).
3.
Adjust the Main tray
paper-width guide (1), as
needed.
4.
Lower the Out tray (4).
Main tray
1 Main tray paper-width guide
2 Main tray release
3 Paper-length guide
4 Out tray
Any supported
photo or plain
paper media—ideal
for envelopes
1.
Load paper print-side
down into the front feed
slot (1). If you are using
tabbed paper, insert the
paper so the tab feeds in
last.
2.
Adjust the front feed slot
paper-width guide (3), as
needed.
Front feed slot
1 Front feed slot
2 Out tray
3 Front feed slot paper-width guide
Stiff media, such as
cardstock (Not
supported: photo
board and banner
printing)
1.
Load paper print-side up
into the rear feed slot (1).
2.
Adjust the rear feed slot
paper-width guide (2), as
needed.
Tips
●
To avoid jams and paper
skewing, load one sheet
at a time straight into the
slot
●
Use only stiff stock media
●
Do not use for photo
board or banner printing
●
Only use this slot when
printing from a computer.
Not for use when printing
from the printer's control
panel.
Rear feed slot
1 Rear feed slot
2 Rear feed slot paper-width guide
Chapter 2
12
HP Photosmart 8700 series