HONDA MK SG-2 - Manual (Page 40)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 40
MAINTENANCE AND TROUBLESHOOTING
16. Rear Wheel Change Out:
NOTE: The two (2) Rear Wheels should be replaced at the same time (MK Diamond Part No. – 158520).
(B)
Locate the Rear Wheel Truck
Assembly
(C)
Remove the Rear Wheel Truck
Assembly Retaining Nuts using
3/4-inch wrenches
(D)
Remove the Rear Wheel Truck
Assembly Retaining Bolts
(G)
Obtain replacement wheels
(F)
Remove the Rear Wheel
Retaining Cotter Pin, Shim
Washer and Rear Wheel from
each side of the Assembly
(A)
Rotate the SG-2 to rest on the
Handle/Stand
Handle/
Stand
Rotation
Direction
(E)
Lower the Rear Wheel Truck
Assembly
Obtain Replacement Wheels
(I)
Install the Rear Wheel Truck
Assembly Retaining Nuts and
Bolts removed in Steps C and
D using 3/4-inch wrenches
(H)
Install the new Rear Wheel,
Shim Washer and Cotter Pin
on each side of the Assembly
Install Rear Wheel
Truck Assembly
Remove
Retaining Nuts
Remove
Retaining Bolts
Rear Wheel
Truck Assembly
Lower Truck
Assembly
Wheel
Cotter
Pin
Shim
Washer
Wheel
Cotter
Pin
Shim
Washer