HONDA MK SG-2 - Manual (Page 23)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 23
SETUP, STARTUP, ADJUSTMENT, OPERATION and SHUTDOWN
3. Cleanup:
Engine parts are extremely hot following use, allow engine to cool 1/2-hour before cleaning. Use
care during cleanup to avoid injury.
NOTE: 1. To extend operating life, the scarifier should be cleaned following every use.
2. Using a garden hose or pressure washer can force water into the air cleaner or muffler opening.
3. Use care when cleaning around electrical components.
(H)
Clean the Shaft Penetration
Hole of the Cutting Drum
(G)
Remove the Cutting Drum
(See Setup Section)
(F)
Clean engine throttle linkage
with a dry cloth
(C)
Clean around the Depth Control
Wheel bearing
Cutting
Drum
Soap and
Water
(A)
Clean the SG-2 with soap
and water
(E)
Clean the remainder of the
exterior surface of the scarifier
(except the engine)
(I)
Clean the Cutting Drum, Shaft
(D)
Clean the Depth
Control Screw
Depth Control
Wheel Bearing
(B)
Verify the engine is off and cool
before beginning to clean
Engine Switch Direction of
Movement
Throttle Linkage
Clean Exterior
Surfaces
Shaft
Penetration
Hole
Clean the
Shaft
Depth Control
Screw