HONDA MK SG-2 - Manual (Page 11)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 11
UNPACKING, TRANSPORT and ASSEMBLY
II. Cutting Drum Disassembly:
NOTE: The Cutting Drum may be disassembled from either end.
(L)
Place a rod in the hole on the
end of the Shaft, and while
holding the Cutting Drum,
remove the Shaft
(K)
Push the Cutting Drum away
from the belt side of the SG-2 to
loosen the Shaft
(J)
Grasp the Cutting Drum as
shown
(M)
Remove the Cutting Drum and
Shaft from the SG-2
Grasp as
shown
Shaft Cutting Drum
Direction of Push
Rod
Pull to
Remove
Hold Drum
Shaft
Cutting
Drum
(C)
Remove the Drum Retaining
Ring
(B)
Remove the 3 Retaining Screws
using a 7/16-inch wrench
(A)
Rotate the Cutting Drum onto
either end and locate the
Retaining Ring, Retaining Screws
Retaining
Ring
Retaining
Screws
Turn counter-
clockwise to loosen
Retaining
Ring