HONDA MK SG-2 - Manual (Page 15)

MK SG-2 Revision 11/01, Effective Date November 13, 2001 Page 15
UNPACKING, TRANSPORT and ASSEMBLY
NOTE: When installing the Oil Dipstick, ensure the threads are aligned with the threads of the Oil Reservoir
so as not to “cross-thread" the dipstick.
4. Filling Fuel Tank:
1. Gasoline is highly flammable and explosive. You can be burned or seriously injured when
handling fuel.
2. To fuel, stop engine if running, and allow it to cool.
3. Refuel in a well-ventilated area.
4. Keep gasoline away from appliance pilot lights, barbecues, electric appliances, power tools,
etc.
5. Wipe up spills immediately.
NOTES: 1. Fuel can damage paint and plastic. Be careful not to spill fuel when filling the fuel tank.
Damage caused by spilled fuel IS NOT covered under the warranty.
2. DO NOT use stale or contaminated gasoline, or an oil/gasoline mixture.
3. Use unleaded gasoline with a pump octane rating of 86 or higher.
(E)
Install Dipstick
Wipe up excess oil Bottom Edge
Dipstick
Turn clockwise
to tighten
(C)
Verify fuel level is below
the throat of the Fuel Tank
(B)
Fill Fuel Tank
(A)
Remove the Fuel Cap
(D)
Install the Fuel Cap
Fill Throat Fill Throat
Turn clockwise
to tighten
Upper Limit
Turn counter-
clockwise to
loosen
(F)
Clean up excess oil
(D)
Add Oil until level reaches
the bottom edge of fill hole
Fuel Cap
Fuel Cap