Safety information, Mercury safety, Regulatory information – HP xp7010/xp7030 User Manual
Page 64: U.s.a
Reference
64
Safety information
Mercury safety
WARNING!
The lamp in this digital projector contains mercury. If the lamp breaks,
adequately ventilate the immediate area, discard any nearby food and drink, and thoroughly
clean the table surface around the projector. Wash your hands after cleaning the area or
handling a broken lamp. Note that disposal of this lamp may be regulated under applicable
environmental laws due to presence of mercury. For disposal or recycling information, please
contact your local authorities or the Electronic Industries Alliance (www.eiae.org). For
additional safety information about the lamp in this digital projector, please see:
www.hp.com/hpinfo/globalcitizenship/environment/productdata
Regulatory information
This section presents information that shows how your digital projector complies with
regulations in certain regions. Any modifications to your digital projector not expressly
approved by HP could void the authority to operate the digital projector in these regions.
U.S.A.
This digital projector has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This digital projector generates, uses, and can radiate radio frequency energy. If not installed
and used in accordance with the instructions, it can cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this digital projector does cause harmful interference to radio or television
reception (which can be determined by unplugging the unit), try the following:
•
Reorienting or relocating the receiving antenna.
•
Relocating the digital projector with respect to the receiver.
•
Connecting the digital projector’s power cord to another power outlet.