beautypg.com

HP xp7010/xp7030 User Manual

Page 53

background image

Connecting to a room controller

53

FWVERS

?

Queries the projector firmware model number and firmware

version. Similar to VERS, but used to verify that a firmware

update image is appropriate for the projector. The

notification takes this form:
*VERS="proj_model:M.mmm"

IPADDR

Hex IP address, ?

Used by network module to tell projector the IP address to

display in the help menu.

SNET

Hex subnet mask, ? Used by network module to tell projector the subnet mask to

display in the help menu.

MAC

Hex MAC address, ? Used by network module to tell projector the MAC address

to display in the help menu.

SNUM

?

Queries the projector's serial number.

RSET

None

Restores all settings to defaults.

Power and status functions

Command

Parameters

Description

SHDN

None

Puts the projector into cool-down state, and later into standby

state. The projector sends a notification when it enters cool-

down state (STAT=3), and another when it enters standby state

(STAT=0). This keyword requires the projector to be in its on

state (STAT=1).
Do not send any requests other than STAT in the time between

the cool-down and standby state notifications. Otherwise,

unexpected results can occur.

W or WAKE

None

Puts the projector into warm-up state, and later into on state.

The projector sends a notification when it enters warm-up state

(STAT=2), and another when it enters the on state (STAT=1).

This keyword requires the projector to be in standby state

(STAT=0).
Do not send any requests other than STAT in the time between

the warm-up and on state notifications. Otherwise, unexpected

results can occur.

Setup functions (continued)

Command

Parameters

Description

This manual is related to the following products: