Setting up, Safety precautions, 1 setting up – HP xp7010/xp7030 User Manual
Page 6
Setting Up
6
1 Setting Up
Safety precautions
WARNING!
Read and observe these precautions and all others in this manual to reduce the
risk of injury and equipment damage.
•
Do not look directly into the lens when the lamp is on.
•
Do not expose the projector to rain or moisture, and do not use it near water.
•
Do not subject the projector to physical abuse or misuse such as exposure to smoke,
unusual stresses, or excessive or continuous (24/7) operation.
•
Keep paper, plastic, and combustible material at least 0.5 m (2 ft) away from the
projector’s lens and exhaust vents.
•
Do not allow liquid, food, or small objects to get inside the projector. If material gets inside
the projector, contact HP for assistance.
•
Do not put anything on top of the projector. Do not place any liquids where they might spill
on the projector.
•
Do not block any vents on the projector. Do not place the projector near any source of heat,
such as a radiator or amplifier.
•
Use only an approved power cord rated for the voltage and current marked on the product
label. Do not overload any outlet or extension cord. Do not circumvent the grounding prong
on the power cord.
•
Route all cables so they are not located where people can step on them or trip on them.
•
Place the projector flat on its base on a sturdy surface or on an HP ceiling mount. Do not
stand the projector on its front surface.
•
Do not touch the lens with your fingers. See “Cleaning the projector lens” on page 39. Use
a soft, dry cloth to clean the projector case.
•
Do not open the projector except as instructed by this manual, and only after allowing the
projector to cool down.
•
If the projector is damaged in any way, contact HP for assistance.