HP xp7010/xp7030 - Manual (Page 52)

Installing Permanently 52
Audio functions
Command Parameters Description
MUTE 0, 1, ? Sets or queries audio muting: 0=not muted, 1=muted.
VOL 0 to 31, +, –, ? Sets or queries audio volume: 0=off, 31=maximum.
INTSP 0, 1, ? Sets or queries usage of the internal speaker (certain models
only): 0=disabled, 1=enabled.
Setup functions
Command Parameters Description
LANG 0 to 10, ? Sets or queries the language used by the projector:
0=English, 1=French, 2=Italian, 3=German, 4=Portuguese,
5=Spanish, 6=Traditional Chinese, 7=Simplified Chinese,
8=Korean, 9=Japanese, 10=Czech.
LSAV 0, 1, ? Sets or queries low-power operating mode: 0=normal
power, 1=low power.
LHRS ? Queries the time (in tenths of hours) that the lamp has been
in use.
THRS ? Queries the total time (in tenths of hours) that the projector
has been in use.
POS 0 to 3, ? Sets or queries the projector’s position: 0=front table,
1=front ceiling, 2=rear table, 3=rear ceiling.
TMO 5 to 120, ? Sets or queries the menu timeout setting (seconds)
PTMO 0, 3 to 6, ? Sets or queries the power timeout: 0=never, 3=15 min,
4=30 min, 5=60 min, 6=120 min.
EDGE 0, 1, ? Sets or queries the cleaning of noise from edges of image:
0=no cleaning, 1=cleaning.
VERS ? Queries the projector model number and firmware version.
The notification takes this form:
*VERS=”proj_model:proj_fw”