Fixing problems, Troubleshooting suggestions, Warning light problems – HP xp7010/xp7030 User Manual
Page 55: If both red warning lights are blinking, If the red temperature light is on, If the red temperature light is blinking, 6 fixing problems
Troubleshooting suggestions
55
6 Fixing Problems
Troubleshooting suggestions
If you have a problem with your projector, check the following statement that most closely
matches the nature of the problem, then look in that section of this chapter:
•
“Warning light problems” on page 55
•
“Start-up problems” on page 56
•
•
•
“Interruption problems” on page 59
•
“Remote control problems” on page 60
TIP:
If these suggestions do not solve your problem, go to http://www.hp.com/support for
additional information. To contact HP, refer to the support guide included with the projector.
Warning light problems
If both red warning lights are blinking:
• Allow the projector to cool down after it turns off. If this condition occurs after you
restart the projector, an internal component has failed. Contact HP for assistance.
If the red temperature light is on:
• Allow the projector to cool down after it turns off. Be sure that nothing is near or
blocking the vents on the projector, and that the vents are free of lint and other objects.
Remove any sources of excess heat in the room. Observe temperature and altitude limits
(see “Specifications” on page 61). If the warning light turns on or blinks after you
restart the projector, contact HP for assistance.
If the red temperature light is blinking:
• Contact HP for assistance.