beautypg.com

Turning the projector off, Moving the projector – HP xp7010/xp7030 User Manual

Page 24

background image

Setting Up

24

Turning the projector off

1.

Press the power button on the projector or remote control to turn off the projector. Do not

hold the button down.
The power button blinks during the cool-down period, then the projector turns off. Even

though the projector is off, it uses a small amount of power internally.

2.

If you want, disconnect video and audio equipment from the projector during the cool-

down period or after the power button stops blinking.

CAUTION:

Do not disconnect power or turn off the disconnect switch until the projector has

cooled down (the fan stops) and the power button stops blinking. Otherwise, you might shorten

the life of the lamp.

3.

If you must unplug or remove the projector, wait until the power light stops blinking, then

unplug the power cord.

If you try to turn on the projector again during the cool-down period, it will not turn on. Wait

until the cool-down period ends and the power button stops blinking.

Moving the projector

When moving the projector:

Allow the projector to cool down before moving it. Then disconnect all cables.

Avoid bumps and jolts. Use a carrying case or padded container when possible.

Observe temperature and humidity limits (see “Specifications” on page 61). If the projector

is cold, allow it to warm gradually to avoid condensation.

This manual is related to the following products: