Arturia KeyStep 37 MIDI Keyboard Controller and Sequencer - Manual (Page 102)

If you double-click in the next step a new note will appear. The overlapped arrow shows that
the two notes are tied:
You can click on the second note and drag the cursor to the right again until the second
note's length value also becomes TIE, and so on.

When the lengths of multiple notes are edited at the same time they will all change to the same
value. A value of Tie does different things for the CV/Gate output and over MIDI:
• CV/Gate output: the note that follows a TIE will change the control voltage but
will not send a new gate signal to the attached device.
• MIDI output: the Note Off command for the first note happens after the Note On
command for the second note. This allows for 'legato'? playing on a monophonic
synthesizer.
97 Arturia - User Manual KeyStep 37 - The MIDI Control Center