Hisense HAIO163 163" Full HD HDR All-in-One LED Commercial Display - Manual (Page 29)

NOTE:
• Installation Steps of the MOBILE CART
Step 1:
As shown in the figure below, use the existing worktable or the packing box as temporarily worktable, with a length
not less than 1300mm, a width not less than 1000mm, a height not less than 410mm, and lay a protective worktable
cloth.
Step 2:
Place the three Horizontal beams on the installation worktable according to the direction shown in the figure.
Note: the arrow face is upward, the arrow direction of the three beams are the same, and the distance between
these three beams is about 573.75mm.
Step 3:
The arrow direction of the crossbeam is the Top side direction of the Mobile Cart. According to the direction shown
in the figure, insert the installation screws on the left and right pillars of the Mobile Cart into the crossbeam, and
then fix the 22 Pcs M8×25 fixing screws and gaskets connecting these five parts (do not fix them too tightly for the
time being).
It is recommended that two people install the left and right sides at the same time to maintain balance. At the
same time, the position of aligning the three beams needs to be accurate, and the two people should keep
synchronized.
In the up-down direction of the left and right columns, put the two L-shaped auxiliary support hooks upward as
shown in the figure. Put the Mobile Cart upright, and tighten 22 fixing screws after checking that there is no
abnormality.
24
LED All-In-One User Manual
Columns on both sides
M8 fixing screws and
gaskets (30 in total)