Hisense HAIO163 163" Full HD HDR All-in-One LED Commercial Display - Manual (Page 12)

【 Description 】
• Powering off the unit directly may damage the hard disk of the OPS module. It is strongly recommended
that you use the following two methods to shut down:
1. When switching off the unit, please use the remote control to make the unit be in a standby mode. At this
time, the OPS module will be shut down normally, followed by the power cutoff.
2. Switch off OPS manually. Switch off the computer switch in the setup menu, or use the start menu in the
computer.
• When OPS is illegally shut down due to the direct power cutoff of this unit, the WINDOWS fix interface
will appear. At this time, the USB keyboard or wireless key board should be used to confirm the fix.
After the fix is complete, the system will continue to enter the system.
OPS Setup
For a brand new OPS module, there is need to enter the BIOS and set the module. Follow the prompts to
enter the BIOS option during the OPS boot process, and do the followings in Advance:
1. Set USB Keyboard/Mouse Wakeup is set as Enabled;
2. Restore AC Power Loss is set as Power Off
3. Enter the power options in the WINDOWS control panel, set the display off time and sleep time to
"Never" respectively, and define the function of the power button as "Shutdown".
【 Description 】
• If the OPS module enters the off state and there is no any operation taken on the computer for a long
time, the unit will enter the standby state. If there is need to use the OPS, restart the computer.
7
LED All-In-One User Manual