Mio volume control (lpf), Mio m/s processor, 274 mio m/s processor – Metric Halo Mobile I/O User Manual
Page 274
+DSP
274
Glide
[0, 1k]
Specifies the rate at which the gain will change. If the Glide value is close to 0 (especially be-
tween .1 and 1), the gain will change slowly. If Glide is close to 1000, the gain will change quickly.
Master Bypass
{On, Off}
When bypassed, the gain will be set to 0dB, passing the input signal unchanged.
MIO Volume Control (LPF)
• Synopsis: MIO Volume Control - Low Pass Filtered Interpolation
• Category: Building Blocks
• Channels: 1, 2, 3, 4, 5, 6, 7, 8
Description:
The output of this plugin is the input with the specified gain applied to each input channel. The gain is
specifed by the
Volume
parameter in dB. The
Glide
parameter controls how quickly the applied gain
will change when you change the
Volume
parameter. This version of the plugin uses a single-pole
low pass filter (LPF) to change the gain between the old value and the new value logarithmically. To
change the gain linearly, use the
Parameters:
Volume
[-120, 20] dB
Specifies the gain applied to the input signal.
Glide
[0, 1k]
Specifies the rate at which the gain will change. If the Glide value is close to 0 (especially be-
tween .1 and 1), the gain will change slowly. If Glide is close to 1000, the gain will change quickly.
Master Bypass
{On, Off}
When bypassed, the gain will be set to 0dB, passing the input signal unchanged.
MIO M/S Processor
• Synopsis: Mid/Side Processor
• Category: Spatial, Building Blocks
• Channels: 2
Description:
MIO M/S is a flexible Mid/Side channel processor. It can be used to decode material that was previ-
ously encoded as Mid/Side. It can also be used to encode a left/right stereo field into a mid/side signal.
In addition to being used to encode or decode existing signals, it you also use two instances of MIO
M/S to build a transcoding signal chain in the +DSP graph.
Since you have access to the individual Mid and Side signals after encoding, you can insert addition-
al processing blocks between the encoder and the decoder, including EQ, delay, compression and
limiting. This allows you to build signal chains that alter the overall size, nature and depth of the
stereo field.
Parameters:
Enable
{Off, On}
When engaged, enables all the processing of the module.
Mid Invert
{Off, On}
When enabled, inverts the 1st input channel before processing.