Metric Halo Mobile I/O - Manual (Page 226)

Routing Examples
226
channel. Since we muted the channel in MIO Console, you won't hear the audio there but will hear
it after it gets routed back into Pro Tools.
For more information on the I/O insert please refer to the I/O insert section of the Mixer Window overview.
If you're using analog outputs 1 and 2 for monitoring, you can use the other 6 analog outputs for sends. You
can also insert whatever DSP processing you want in the MIO Console mixer channels to pre or post process
your hardware inserts!
In this scenario, Pro Tools' delay compensation will be accurate.
DSP Inserts
Using your 2d and +DSP effects via the I/O insert is a great way to integrate your interface's processing into
your session. Add the insert paths to your session's I/O setup like we did for analog inserts and create the
corresponding routing in MIO Console:
Figure 13.40: Configuring the MIO Mixer, DAW 15-16
1. Create a DAW channel for each insert send and assign the post-insert direct out to the corresponding
FW channel. Assign the channelstrip to your monitor bus (so that the meters will be active) and make
sure to mute it. Insert whatever processing you want in the inserts.