AltiGen MAXCS 7.5 Polycom Configuration Guide - Manual (Page 20)

Polycom Configuration Guide Page 20 of 24
Configure Polycom Paging
Once you have enabled Polycom Paging for an extension, the user can subscribe to paging groups, change the
default paging group, configure whether pages play during active calls, and send pages.
To configure Polycom Paging groups,
1. In MAXCS Administrator, select PBX > Paging Group Configuration.
2. Click Add to add a new group.
3. Enter the paging group number.
4. Check Polycom paging group.
5. Assign an available paging channel ID number for the group (1-25).
6. Click OK. You will see the new group in the Paging Group page, in the left panel. Polycom groups will show
(Polycom) to the right of the number.
•
Modify the group information as needed. For the First Name and Last Name fields, enter details up
to a maximum of 32 characters. You can also enter a description for this group.
7.
To add extensions to Polycom Paging groups, select the group in the list and open the Group Member tab.
Move extensions from the Not Member list to the Member list. Click Apply.
Figure 30: Add a new paging group
Figure 31: Information for the new Polycom paging group