LumaSense Technologies INNOVA 1316A-2 - Manual (Page 85)

Chapter 4
_________________________________________________________________________________________
_____________________________________________________________________________
BE6021-11 1316A-2 Multi Gas Monitor LumaSense Technologies A/S
Instruction Manual Page 85 of 97
Warning: never attempt to send the new NO sensor command after a
NO span calibration unless a new NO sensor has been installed.
The Low NO Sensor Limit is calculated and saved.
4.4 Reset Span Calibration
At any time it is possible to return to the factory saved calibration
factors.
Pull down the Bench Command Menu.
Select Reset Span.