IEI Integration ECW-281B-N270-WT v2.10 - Manual (Page 71)

ECW-281B-R21/N270 Embedded System
Page 55
All peripheral devices (VGA monitor, serial communications devices etc.) are
connected
The power cables are plugged in
The system is securely mounted
4.3.2 Terminal Block Pinouts
The terminal block pinouts are shown in
769H769H771H
Figure 4-14 .
Figure 4-14: Terminal Block Pinouts
The chassis ground is connected to the ECW chassis internally. The cable ground is
connected to the ground pin on the input power connector of the power module.
4.3.3 Power-on Procedure
To power-on the ECW-281B/281B2-R21/N270 please follow the steps below:
Step 1: Push the power button.
Step 2: Once turned on, the power button should turns to blue. See
770H770H772H
Figure 4-15 .
Step 0: