3 more troubleshooting, 3 component replacement procedure – IEI Integration ECW-281B-N270-WT v2.10 User Manual
Page 137
ECW-281B-R21/N270 Embedded System
Page 121
7.2.3 More Troubleshooting
Nothing appears on the monitor after booting up the system: Make sure
the monitor is properly connected to the system and the monitor is connected
to a power supply and turned on.
WARNING!
If all troubleshooting measures have been taken and the system still
fails to start, contact the IEI reseller or vendor you purchased the
ECW-281B/281B2-R21/N270 from or contact an IEI sales
representative directly. To contact an IEI sales representative, please
send an email to
301H301H302H
.
7.3 Component Replacement Procedure
WARNING!
Users are not advised to attempt to repair or replace any internal or
external components of the ECW-281B/281B2-R21/N270 embedded
system other than those listed below. If any other components fail or
need replacement, contact the IEI reseller or vendor you purchased the
ECW-281B/281B2-R21/N270 from or contact an IEI sales
representative directly. To contact an IEI sales representative, please
send an email to
302H302H303H
.
The embedded system components listed below can all be replaced if they fail:
SO-DIMM
module
Internal hard disk drive (see Section
837H837H839H
4.2.5
)