IEI Integration ECW-281B-N270-WT v2.10 - Manual (Page 55)

ECW-281B-R21/N270 Embedded System
Page 39
Jumper Settings: See
830H740H740H742H
Table 3-21
Jumper Location: See
831H741H741H743H
Figure 3-20
If the ECW-281B/281B2-R21/N270 fails to boot due to improper BIOS settings, the clear
CMOS jumper clears the CMOS data and resets the system BIOS information. To do this,
use the jumper cap to close pins 2 and 3 for a few seconds then reinstall the jumper clip
back to pins 1 and 2.
If the “CMOS Settings Wrong” message is displayed during the boot up process, the fault
may be corrected by pressing the F1 to enter the CMOS Setup menu. Do one of the
following:
Enter the correct CMOS setting
Load Optimal Defaults
Load Failsafe Defaults.
After having done one of the above, save the changes and exit the CMOS Setup menu.
The clear CMOS jumper settings are shown in
832H742H742H744H
Table 3-21 .
AT Power Select Description
Short 1 - 2 Keep CMOS Setup Default
Short 2 - 3 Clear CMOS Setup
Table 3-21: Clear CMOS Jumper Settings
The location of the clear CMOS jumper is shown in
833H743H743H745H
Figure 3-20 below.
Figure 3-20: Clear CMOS Jumper