B.2 setup procedure for windows, B.2.1 hardware and bios setup – IEI Integration ECW-281B-N270-WT v2.10 User Manual
Page 149

ECW-281B-R21/N270 Embedded System
Page 133
NOTE:
Installing unsupported OS versions may cause the recovery tool to fail.
B.2 Setup Procedure for Windows
Prior to using the recovery tool to backup or restore Windows system, a few setup
procedures are required.
Step 1:
Hardware and BIOS setup (see Section
769H769H851H851H853H
B.2.1
)
Step 2:
Create partitions (see Section
770H770H852H852H854H
B.2.2
)
Step 3:
Install operating system, drivers and system applications (see Section
771H771H853H853H855H
B.2.3
)
Step 4:
Build-up recovery partition (see Section
772H772H854H854H856H
B.2.4
)
Step 5:
Create factory default image (see Section
773H773H855H855H857H
B.2.5
)
S
te
p
0
:
The detailed descriptions are described in the following sections.
NOTE:
The setup procedures described below are for Microsoft Windows
operating system users. For Linux system, most setup procedures are
the same with Microsoft Windows except for several steps which is
described in Section
774H774H856H856H858H
B.3
.
B.2.1 Hardware and BIOS Setup
Step 1:
Make sure the system is powered off and unplugged.
Step 2:
Install a hard drive or SSD in the system. An unformatted and unpartitioned disk
is recommended.
Step 3:
Connect an optical disk drive to the system and insert the recovery CD.