IEI Integration ECW-281B-N270-WT v2.10 User Manual
Page 64
ECW-281B-R21/N270 Embedded System
Page 48
Step 7:
Adhere the thermal pad to the HDD. Make sure there is no obstacle covering the
breather hole (
758H758H760H
Figure 4-5
).
CAUTION:
Make sure the breather hole of the HDD is not covered. Covering the breather
hole may cause damage to the HDD.
Figure 4-5: HDD Thermal Pad
Step 8:
Replace the HDD bracket onto the bottom surface by aligning the four retention
screw holes in the HDD bracket with those in the back of the bottom surface.
Step 9:
Reinsert the four previously removed retention screws.
Step 10:
Connect the SATA cable connector in the ECW-281B/281B2-R21/N270 to the
HDD.
Step 11:
Replace the bottom surface to the bottom panel by reinserting the six previously
removed retention screws.
Step 0: