IEI Integration ECW-281B-N270-WT v2.10 - Manual (Page 59)

ECW-281B-R21/N270 Embedded System
Page 43
4.1 Anti-static Precautions
WARNING:
If the following anti-static precautions are not followed, a user may be
injured and the system irreparably damaged.
Electrostatic discharge (ESD) can cause serious damage to electronic components,
including the WAFER series motherboard and the power module. (Dry climates are
especially susceptible to ESD.) It is therefore critical that whenever the
ECW-281B/281B2-R21/N270 is opened and any electrical component handled, the
following anti-static precautions are strictly adhered to.
Wear an anti-static wristband: - Wearing a simple anti-static wristband can
help to prevent ESD from damaging the board.
Self-grounding:- Before handling the board, touch any grounded conducting
material. During the time the board is handled, frequently touch any
conducting materials that are connected to the ground.
4.2 Installation Procedure
4.2.1 Installation Procedure Overview
To properly install the ECW-281B/281B2-R21/N270, the following steps must be followed.
Detailed descriptions of these instructions are listed in the sections that follow.
Step 1: Unpacking
Step 2: Configure the jumper settings
Step 3: Install the SATA hard disk drive (HDD)
Step 4: Mount the ECW-281B/281B2-R21/N270
Step 5: Connect the front panel peripheral connectors