Inova PD00941013.001 - Manual (Page 88)

©2004 Inova Computers GmbH Page D-4 ICP-P4/PM/CM Appendix-D
IPM-ATA Appendix D
D1.2 IPM-ATA-HD
The IPM-ATA-HD has provision for one standard notebook (2.5”) EIDE device (FLASH or hard-disk)
and one Compact FLASH or MicroDrive site. Figure D1.2 illustrates the significant connectors for
this device while Table D1.2 indicates the jumper positions for the various Master/Slave device
configurations.
Figure D1.2 IPM-ATA-HD Board Layout
1
2
3
Table D1.2 IPM-ATA-HD Jumper Description (CF Socket)
It should be noted that the secondary IDE channel (from rear I/O) only is available for use by the
IPM-ATA-HD (the primary is on the CPU board itself). Multi Master or multi Slave configurations
are not supported and will not work!
Jumper J6
2-3
Open
CompactFlash
or MicroDrive in J3
Master
Slave
Note:
The hard disk is jumpered seperately for
Master / Slave operation