HP Compaq nx5000 series - Manual (Page 189)

Maintenance and Service Guide B–1
B
Power Cord Set Requirements
3-Conductor Power Cord Set
The wide range input feature of the notebook permits it to operate
from any line voltage from 100 to 120 or 220 to 240 volts AC.
The power cord included with the notebook meets the
requirements for use in the country where the equipment
is purchased.
Power cords for use in other countries must meet the
requirements of the country where the notebook is used. For
more information on power cord requirements, contact an HP
authorized reseller or service provider.
General Requirements
The requirements listed below are applicable to all countries:
■ The length of the power cord must be at least 1.5 meters
(5.00 feet) and a maximum of 2.0 meters (6.50 feet).
■ All power cords must be approved by an acceptable
accredited agency responsible for evaluation in the country
where the power cord will be used.
■ The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet C13
connector for mating with the appliance inlet on the back of
the notebook.