HP 744 - Manual (Page 128)

A-12
The Boot Console Interface
Restoring the Factory Default Configuration
Restoring the Factory Default Configuration
To restore the factory default values in the EEPROM, follow the directions
in “Accessing the Boot Console Interface” earlier in this chapter, and then
type the following at the prompt to access the Configuration Menu:
Main Menu: Enter command > co
When the Configuration Menu appears, type the following at the prompt:
Configuration Menu: Enter command > default
The process takes less than 30 seconds and messages similar to the follow-
ing are displayed:
Initializing...
TEST 30CD
INIT 30CD
Configuration Menu: Enter command >
The factory default EEPROM settings are now restored. This process does
not affect the VME configuration in the EEPROM.
The defaults are as follows:
OS_ID: HP-UX
Fast Size: 0xF (all memory is tested)
Primary Path: sescsi.6.0
Alternate Path: sescsi.5.0
Console Path: GRAPHICS(n) where n is the lowest numbered
device installed. If no graphics devices are
installed this is set to SERIAL_1.
Keyboard Path: PS2
Autoboot: OFF
Autosearch OFF
Autostart ON