HP 3500 User Manual

Page 130

6. Guide the left side of the transfer unit into the front door of the printer. Insert the two

pegs on the left side into the holes, and then lower the right side into the door.

7. Make sure that the blue button on the right blue handle has released (popped up). If the

button has not released, grasp the right blue handle and pull the transfer unit toward
you.

8. Firmly close the front door.

9. After the front door is closed, after a short time, the printer control panel displays the

message NEW TRANSFER KIT.

10. If the message NEW TRANSFER KIT appears, go to step 11. If the message does not

appear, you must reset the transfer unit count. See

11. On the printer control panel, press

to highlight YES, and then press

to select it. The

transfer unit count is reset and the printer is ready to use.

118

Chapter 7 Maintenance

ENWW