HP 2/8q Fibre Channel - Manual (Page 147)

Command Line Interface
147 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
STATE [STATE]
Specifies one of the following administrative states for the specified port:
Online —Places the port online. This activates and prepares the port to send data.
Offline —Places the port offline. This prevents the port from receiving signal and
accepting a device login.
Diagnostics —Prepares the port for testing. This prepares the port for testing and
prevents the port from accepting a device login.
Down —Disables the port by removing power from the port lasers.
Set Setup
command
Changes SNMP and system configuration settings. The switch maintains one SNMP
configuration and one system configuration.
Authority
Admin
Syntax
SET SETUP
Keywords
SNMP
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table 55 describes the SNMP parameters. For each parameter, enter a new value or
press Enter to accept the current value shown in brackets.
Table 55: SNMP configuration settings
Entry Description
SNMPEnabled Enables (True) or disables (False) SNMP on the switch. The
default is True.
Contact Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding #,
semicolon (;), and comma (,). The default is undefined.
Location Specifies the name of the switch location. The name can be up
to 64 characters excluding #, semicolon (;), and comma (,).
The default is undefined.
Trap [1-5] Address Specifies the workstation IP address to which SNMP traps are
sent. The default address for trap 1 is 10.0.0.254. The default
address for traps 2–5 is 0.0.0.0. Addresses, other than
0.0.0.0, for all traps must be unique.
Trap [1-5] Port Specifies the workstation port to which SNMP traps are sent.
Valid workstation port numbers are 1–65535. The default is
162.
Trap [1-5] Severity Specifies the severity level to use when monitoring trap events.
The default is Warning
Trap [1-5] Version Specifies the SNMP version (1 or 2) to use in formatting traps.
The default is 2.
Trap [1-5] Enabled Specifies whether traps (event information) are enabled or
disabled (default).