HP 2/8q Fibre Channel - Manual (Page 144)

Command Line Interface
144 HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
The following is an example of the SET CONFIG ZONING command:
2/8q FC Switch #> admin start
2/8q FC Switch (admin) #> config edit
2/8q FC Switch (admin-config) #> set config zoning
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current
value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
InteropAutoSave (True / False) [True]
Default Visibility (All / None) [All ]
Finished configuring attributes.
This configuration must be saved (see config save command) and
activated (see config activate command) before it can take effect.
To discard this configuration use the config cancel command.
Set Log
Command
Specifies the events to record in the event log and display on the screen. You determine what
events to record in the switch event log using the
Component , Level , and Port keywords.
You determine what events are automatically displayed on the screen using the Display
keyword. Alarms are always displayed on the screen.
Authority
Admin
Syntax
SET LOG
Keywords
ARCHIVE
Collects the most recent 200 entries plus the previous 1000 entries and stores the
result in new file named
logfile that is maintained in switch memory where it can
be downloaded using FTP. To download logfile , open an FTP session, log in with
account name/password of images for both, and type get logfile .
CLEAR
Clears all log entries.
COMPONENT [filter_list]
Specifies one or more components given by [filter_list] to monitor for events. A
component is a firmware module that is responsible for a particular portion of switch
operation. Use a to delimit values in the list. [filter_list] can be one or more
of the following:
MGMTSERVER —Monitors management server status.
NAMESERVER —Monitors name server status.