Keywords – HP 2/8q Fibre Channel User Manual
Page 132

Command Line Interface
132
HP StorageWorks 2/8q Fibre Channel Switch Management User Guide
Keywords
CONFIG [CONFIG_NAME]
Resets the configuration given by [config_name] to the factory default values for
switch, port, port threshold alarm, and zoning configuration. If [config_name] does
not exist on the switch, a configuration with that name is created. If you omit
[config_name], the active configuration is reset. You must activate the configuration
for the changes to take effect. See
through
for switch, port, and port
threshold alarm configuration default values.
FACTORY
Resets switch configuration, port configuration, port threshold alarm configuration,
zoning configuration, SNMP configuration, system configuration, and zoning to the
factory default values. The switch configuration is activated automatically. See
through
.
Note:
Because this keyword changes network parameters, the workstation could lose
communication with the switch and release the Admin session.
PORT [PORT_NUMBER]
Reinitializes the port given by [port_number]. Ports are numbered beginning with 0.
SNMP
Resets the SNMP configuration settings to the factory default values. See
SNMP configuration default values.
SWITCH
Resets the switch without a power-on self test. This is the default. This reset disrupts
traffic and does the following:
— Activates the pending firmware.
— Closes all management sessions.
— Clears the alarm log. To save the alarm log before resetting, refer to the “
To reset the switch with a power-on self test, refer to the “
SYSTEM
Resets the system configuration settings to the factory default values. See
for
system configuration default values.
Note:
Because this keyword changes network parameters, the workstation could lose
communication with the switch.
ZONING
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.