HP D3604-90004 - Manual (Page 36)

3 Installing Hardware Accessories
30
NOTE Do not dispose of the blank filler panel. If you decide to operate
the storage system with an empty bay, it must be covered with a
blank filler panel to ensure proper cooling, and compliance with
RFI and safety standards.
6. Mount the device in an HP tray if necessary.
7. Configure the device per manufacturer’s instructions.
8. Secure the drive and tray in the SCSI device shelf using the same screws
used to attach the filler panel.
9. Attach the SCSI cable for the appropriate configuration. Refer to the
“Cabling Configuration” section of this manual for additional
information.
10. Attach the power connector to the device.
11. Replace the door and the bezel of the storage system.
12. Reconnect the power cords and cables.
13. Power up the storage system, allowing the drives to spin up to speed.
14. Configure the drive as described in your host system’s user guide.