HP D3604-90004 - Manual (Page 33)

3 Installing Hardware Accessories
27
En
g
li
s
h
Figure 3-2. Installing the Hot-Swap Disk Module
Removing a Hot-Swap Disk Module
This section describes the process for removing a hot-swap disk module.
CAUTION The module may be spinning and may be warm to touch.
Complete the following procedure to remove a disk module:
1. Verify the hot-swap disk module keylock is unlocked, and unlock the hot-
swap disk module by pushing the locking tab down and lifting the front
lever.
2. Support the bottom of the module as shown in Figure 3-3. Slowly pull the
module straight out. Do not allow the hot-swap disk module to fall.