Humax F2-FOX User Manual
Page 47
**
DiSEqC Input
You can select DiSEqC switch.
1. Select DiSEqC Input using the
button, and press the OK
or
button.
Select the DiSEqC Swtich using the
button, and press the
OK
button.
You can select one option among Tone burst A~B, DiSEqC
A~D, DiSEqC A~D for 2.0 and Disable.
**
LNB Voltage
You can raise the LNB Voltage value (select High ) preparing for the distance between antenna and receiver
is further than 60m.
Caution:
If your set the LNB Voltage value as High when the distance
between antenna and receiver is close, the LNB may be
damaged. Please be careful.
1. Select LNB Voltage using the
button, and press the OK
or
button.
2. Set the LNB Voltage value using the
button, and press
the OK
button.
Standard
If the distance between antenna and receiver is
within 60m
High
If the distance between antenna and receiver is
further than 60m
3. If you change the setting value to High a message will prompt
you to confirm. Select Yes and press the OK
button. When
the value is set to High , 1V higher than LNB voltage is supplied
to LNB.
**
**
**
GB 47
**
**
**
**
**
**
**
**
**
**
**
**
**
**