HP R717 - Manual (Page 15)

15 Getting Started
4. Charge the Battery
You can charge a battery in the camera (explained here) or
in the extra battery bay of the camera dock or in the
HP Photosmart quick recharger (see Purchasing Camera
Accessories on page 193).
If your camera battery is a disposable Duracell® CP1
battery, skip this procedure. If the battery is a rechargeable
Lithium Ion battery:
1. Plug the power cord into the HP AC power adapter. If
more than one power cord is in the box, use the cord that
is appropriate for power outlets in your country. Plug the
other end of the power cord into an electrical outlet.
2. Open the small rubber
door on the side of the
camera.
3. Attach the thin cord from
the HP AC power adapter
to the power adapter
connector on the side
of the camera as shown.
The Power/Memory light on the back of the camera will
start blinking to show that the battery is charging.
The rechargeable Lithium Ion battery will usually charge fully
in 4-6 hours in the camera. When the Power/Memory light
stops blinking, the battery is fully charged, and you can then
unplug the HP AC power adapter from the camera. You can
continue to use the camera while the battery is being
charged by the HP AC power adapter.
NOTE: The camera may get warm while it is charging the
battery, as well as after prolonged use under battery
power. This is normal.