HP CM1312 MFP Series - Manual (Page 128)

activated, you can dial a fax number without the dial prefix by using manual dial. For instructions, see
Manual dial faxing on page 129 .
1. On the control panel, press Setup .
2. Use the arrow buttons to select Fax setup, and then press OK .
3. Use the arrow buttons to select Basic setup, and then press OK .
4. Use the arrow buttons to select Dial Prefix, and then press OK .
5. Use the arrow buttons to select On or Off, and then press OK .
6. If you selected On, use the alphanumeric buttons to enter the prefix, and then press OK . You can
use numbers, pauses, and dialing symbols.
Set the dial-tone detection
Normally, the product begins dialing a fax number immediately. If you are using the product on the same
line as your telephone, turn on the detect-dial-tone setting. This prevents the product from sending a
fax while someone is on the telephone.
The factory-set default for detect dial tone is On for France and Hungary, and Off for all other countries/
regions.
1. On the control panel, press Setup .
2. Use the arrow buttons to select Fax setup, and then press OK .
3. Use the arrow buttons to select Advanced setup, and then press OK .
4. Use the arrow buttons to select Detect dial tone, and then press OK .
5. Use the arrow buttons to select On or Off, and then press OK .
Set autoredial
If the product was unable to send a fax because the receiving fax machine did not answer or was busy,
the product attempts to redial based on the redial-on-busy, redial-on-no-answer, and redial-on-
communication-error options. Use the procedures in this section to turn these options on or off.
Set the redial-on-busy option
If this option is turned on, the product redials automatically if it receives a busy signal. The factory-set
default for the redial-on-busy option is On.
1. On the control panel, press Setup .
2. Use the arrow buttons to select Fax setup, and then press OK .
3. Use the arrow buttons to select Advanced setup, and then press OK .
4. Use the arrow buttons to select Redial if busy, and then press OK .
5. Use the arrow buttons to select On or Off, and then press OK .
116 Chapter 12 Fax (fax models only) ENWW