beautypg.com

A. intellifire (ipi) ignition system (continued) – Heat & Glo Fireplace LUX60 User Manual

Page 53

background image

Heat & Glo • LUX60 • 4062-116 • Rev. G • 4/11

53

A. IntelliFire (IPI) Ignition System (continued)

Symptom

Possible Cause

Corrective Action

4. Pilot lights but continues

to spark, and main burner
will not ignite. (If the pilot
continues to spark after
the pilot fl ame has been lit,
fl ame rectifi cation has not
occurred.)

A. A shorted or loose connection

in fl ame sensing rod.

Verify all connections to wiring diagram in manual. Verify
connections underneath pilot assembly are tight. Verify
connections are not grounding out to metal chassis, pilot burner,
pilot enclosure or screen if present, or any other metal object.

B. Poor fl ame rectifi cation or

contaminated fl ame sensing
rod.

With fi xed glass assembly in place, verify that fl ame is engulfi ng
fl ame sensing rod on left side of pilot hood. Flame sensing rod
should glow shortly after ignition. Verify correct pilot orifi ce is
installed and gas inlet is set to pressure specifi cations.

C. Module is not grounded.

Verify module is securely grounded to metal chassis of appliance.
Verify that wire harness is fi rmly connected to the module.

D. Damaged pilot assembly or

contaminated fl ame sensing
rod.

Verify that ceramic insulator around the fl ame sensing rod is not
cracked, damaged, or loose. Verify connection from fl ame sensing
rod to white sensor wire. Clean fl ame sensing rod with emery
cloth to remove any contaminants that may have accumulated on
fl ame sensing rod. Verify continuity with a multimeter with ohms
set at lowest range. Replace pilot if any damage is detected.

E. Module.

Deactivate the fi replace with the POWER button of the remote.
Remove ignitor wire “I” from module. Reactivate the fi replace
with the POWER button of the remote. If there is no spark at
“I” terminal module must be replaced. If there is a spark at “I”
terminal, module is fi ne.