HP D6028-90004 - Manual (Page 98)

Appendix F LED Codes
92
For example, a 2-1-1-2 error (DRAM Error) would appear as:
flash-flash, pause, flash, pause, flash, pause, flash-flash, pause
The failure pattern repeats indefinitely.
Failure Codes
The table below lists the error or report codes, which are flashed by the HP
TopTools Remote Control card’s red diagnostic LED. A flashing red LED always
indicates a problem with the card’s operation.
To determine a Suggested Action, note the first three digits of the error and refer
to the Report Code in the following table. The fourth digit is represented by an
"X" because the number is irrelevant to the analysis.
Table F-1. Failures and Suggested Actions
Report Code
(
Red LED blink pattern)
Failure Reason Suggested
Action
LED on continuously ASIC CPU Subsystem Error See action 1
1111 FLASH-ROM Error See action 2
211X DRAM Error See action 3
311X LAN Interface Error See action 1
411X RS-232 Interface Error See action 1
511X PCI Interface Error See action 1
611X ICMB Error See action 1
The "X" in the report code represents a possible number between 1 and 9 and is
not significant.
Suggested Actions
The following remedies refer to the Suggested Actions listed in the last column of
Table F-1 above.
Action 1: First verify the fault. Disconnect the AC/DC adapter from the
card and cycle power at the server to restart HP TopTools Remote Control.
If the same error is reported again, call your local support center.