Lan configuration – HP D6028-90004 User Manual
Page 31
Chapter 4
Setting Up the Remote Connection
25
HP TopTools Remote Control for HP NetServers Card Setup
PPP Settings
Figure 4-2. Main Setup Screen
The displayed value on any of the setting screens is updated as soon as an entered
value is validated.
LAN Configuration
For a remote connection to the TopTools Remote Control card via LAN, the LAN
Settings screen is used to set up the connector on the card. If you are not sure
how to set network parameters, contact your network administrator for the
correct network settings.
NOTE
The HP TopTools Remote Control card requires its own
unique IP address (different from the server’s IP address) since
it functions independently of the server on which it is
installed.
Press the desired letter (D, I, N, or G) on the keyboard to change one of your
Local Area Network settings. An entry window pops up that allows the entry of
the new value. Closing this entry window initializes the validation of the new
entry. If it is valid it will be updated on the corresponding setting screen,
otherwise an error message occurs. Press M to return to the Main Setup Screen.
HP TopTools Remote Control for HP NetServers - LAN Settings
Set IP-Address 192.168.10.10
Figure 4-3. Local Area Network Configuration