HP D6028-90004 - Manual (Page 63)

57
A Event Codes
The table below describes the event codes that can be listed in the event log and
optionally directed to specified users via e-mail or pager. When the HP TopTools
Remote Control card sends notification about a server event, it includes the
server identifying number and a five-digit code identifying the event. (If you use
email or a TAP pager, you will receive the server name and some descriptive text
as well.)
In the Severity column, an asterisk (*) indicates that the severity rating depends
on particular data for the event. The final column indicates which NOS agents
need to be loaded on the HP NetServer before the particular event is generated.
Refer to the HP NetServer SNMP agents documentation (viewable in HP
Information Assistant on the NetServer Documentation CD) for agent installation
and configuration instructions.
NOTE It’s a good idea to copy appropriate sections of this table and
keep it with the pager you use to receive notifications. A
regularly updated list of HP supported event codes is available
via the WWW at http://www.hp.com/go/netserver.
Notification and log messages are limited to a length of 40 characters.
Event
Code
Severity Description Agent
System Power
00201 * Voltage +5V Threshold None
00202 * Voltage -5V Threshold None
00203 * Voltage +12V Threshold None
00204 * Voltage -12V Threshold None
00206 * Voltage +3.3V Threshold None
00207 Warning SCSI Terminator Voltage Limit Exceeded None
00210 * Primary CPU Voltage Threshold None
00211 * Secondary CPU Voltage Threshold None
00800 * Redundant Power Supply Removed or Inserted None
00801 Warning Redundant Power Supply Aux or DC Power Failure None
00900 Informational Redundant Power Supply Unit Redundancy Gained None