HP D6028-90004 User Manual

Page 47

6 Setting Up NT Graphics Console

Redirection Using pcANYWHERE32

For NetServer systems running Microsoft Windows NT 3.51 or 4.0, you can
redirect the server’s NT graphics console to a remote PC client to remotely
perform operations as if you were sitting at the server. To do this, you must
install pcANYWHERE32 software. pcANYWHERE32 components must be
installed and configured at both the server and the remote client to use NT
remote control. The figure below show how it works:

NetServer

At the Server: after
installing pcANYWHERE32
and configuring it for LAN
and/or modem
communications, the
server may be taken over
by the remote client via a
LAN and/or modem
connection.

At the Remote Client Using
a Modem: the user dials into
HP TopTools Remote
Control, selects "NT Remote
Control," hangs up and dials
back to the server using
pcANYWHERE32 and takes
full graphics control of the
HP NetServer.

Remote

Console

Modem

LAN

At the Remote Client Using
the LAN: the user launches
pcANYWHERE32 and takes
full graphics control of the
HP NetServer.

LAN

Figure 6-1. NT Console Redirection to a Remote Client