HP D6028-90004 - Manual (Page 50)

Chapter 6 Setting Up NT Graphics Console Redirection Using pcANYWHERE32
44
3. Make a new connection item for your server. Double-click the "Add Be a
Host PC Item".
4. Configure the connection item for LAN or modem use.
◊ LAN connection: Select TCP/IP as the connection device.
◊ Modem connection: You will be prompted for a Host Name and
connection device. Select the COM port (not modem) assigned by the
HP TopTools Remote Control card’s serial driver (see previous
section).
With your selected COM port highlighted, click Details and check the
communications parameters assigned to the port. Configure the port as
shown in Figure 6-3.
Figure 6-3. Configuring the Server-side COM Port in pcANYWHERE32
NOTE You can configure the pcANYWHERE32 host to wait for both
a modem and LAN connection by checking both a COM port
and TCP/IP in the host icon’s "Properties."