HP D6028-90004 - Manual (Page 8)

Chapter 1 Quick Start
2
Install and set up hardware at the server (see Chapter 3 for detailed instructions):
1. Mount the battery pack on the HP TopTools Remote Control PCI card and
connect the battery cable to the battery pack connector (see Figure 1-1).
2. Connect one end of the supplied I 2 C/IPMB cable to the connector on the
HP TopTools Remote Control card.
3. Install the HP TopTools Remote Control card in one of the server’s free
PCI slots.
NOTE HP does not support installations of the HP TopTools Remote
Control card in systems that do not include the I
2
C/IPMB
management bus feature. HP NetServers such as the LC 3 and
LH 3 include this feature. If you don’t have one of these
systems, refer to your system documentation for more
information.
4. Connect the free end of the I 2 C/IPMB cable to the I 2 C/IPMB management
bus connector on the server’s system board. The connector is keyed and
color coded.
5. If applicable, plug in the optional 5-volt AC/DC power adapter to the
connector on the card’s bracket. Plug the AC/DC adapter power cord into
a wall outlet or uninterruptible power supply.
Set up the remote connection (see Chapter 4 for detailed instructions):
1. Set up the LAN or modem connection that allows the HP TopTools
Remote Control card to communicate with a remote client:
◊ For a LAN connection: Connect your dedicated 10Base-T compatible
LAN line to the card’s RJ-45 LAN connector.
◊ For a modem connection: Connect a serial modem cable (not
provided) to the card’s serial port and connect the other end to an
external modem.
2. Boot the server. During Power-On Self-Test, when prompted, press F3 to
enter the HP TopTools Remote Control BIOS setup program.
◊ If you plan on connecting to the TopTools Remote Control card via
the LAN: Define card’s TCP/IP properties (either use a unique IP
Address for the card, Subnet Mask, and Gateway, or enable DHCP and
have your DHCP server assign these addresses for you).