HP D6028-90004 - Manual (Page 48)

Chapter 6 Setting Up NT Graphics Console Redirection Using pcANYWHERE32
42
Installing pcANYWHERE32 on the Server
To enable console redirection (the ability to redirect what’s graphically displayed
on your server) either over the LAN or via modem, you must first install the
pcANYWHERE32 host software, included with your system, on your HP
NetServer.
NOTE Remember that the HP TopTools Remote Control card
software license authorizes a single administrator for each
copy of software (including Symantec’s pcANYWHERE32).
Console Redirection Over a LAN
If you want console redirection (remote control) of your server over a LAN
(instead of using a modem with pcANYWHERE32), you must have TCP/IP
software installed on your server. TCP/IP is available with the standard Windows
NT product.
Installing pcANYWHERE32 Server Software
Installing pcANYWHERE32 at the server requires administrator privileges in
order to configure the program’s communications features. Your server must be
running either Windows NT 3.51 or 4.0.
To install the pcANYWHERE32 software at your Windows NT server:
1. Log in to Windows NT with administrator privileges. You need to be the
system administrator, or have an account that belongs to the administrator
group.
2. Insert the HP NetServer Navigator CD (supplied with HP TopTools
Remote Control) in the CD-ROM drive.
3. If you want to run pcANYWHERE32 via the modem connected to the HP
TopTools Remote Control card, install the appropriate NT serial driver by
running one of the following NT driver setup programs.
For Windows NT 4.0, the driver is located in:
x :\ttrc\us\nt40drvr\setup.exe
For Windows NT 3.51, the driver is located in:
x :\ttrc\us\nt35drvr\setup.exe
where x: is the letter of your CD-ROM drive. Follow the on-screen setup
instructions.