Home Dynamix ANEXX A - Manual (Page 88)

4 Ports 11g Wireless ADSL2/2+ Router 81
4.4.4.1 IP QoS Rule Setup
The IP QoS Rule Setup page allows you to define a traffic rule for a specified connection. Use the following
procedures to access the IP QoS Rule Setup Page.
1. From the IP QoS Setup page, Choose A Connection filed, select the specific connection you want to
define the IP QoS traffic rules.
2. Check Enable IP QoS.
3. Click Add.
4. Click Apply to temporarily save the setting.
5. To make the change permanent , click on Save All.
The Rules configuration page will allow you to define IP matching fields to associate with the priority queues
associated with the named connections selected above in the "QoS Setup Page" section.
There will be three primary fields for you to select:
„ A Trusted mode check box.
„ A traffic priority choice (High, Medium, Low).
„ An IP rules matching selection area.
The 4 Ports 11g Wireless ADSL2/2+ Router has two primary modes of operation with regard to queue traffic
prioritization: Trusted and Un-trusted. The Web UI will provide one check box to enable trusted mode. In
"Trusted mode" all rules will be applied first, regardless of the setting of the TOS bits. After the rules have
been exhausted the existing TOS bit settings will be honored. If the "Trusted mode" box is unchecked this will
indicate the "Un-trusted mode." "Un-trusted" mode will match first against all rules as in "Trusted" mode. The
difference is that if there is no match then a default rule will be used. The default rule will have an associated
queuing priority - Low.