Hitachi ULTRASTAR 15K450 HUS154530VLF400 User Manual
Page 112
Hitachi Ultrastar 15K450 (FC-AL) Hard Disk Drive Specification
96
Note: Common FC Services are used to communicate with the Fabric Name Server and are only issued by the drive when it is
operating as a Public Loop Device.
Table 81: Payload of a CT Header
The FC_CT field contains the FC_CT revision. The drive always sets this value to 0x01.
IN_ID is a reserved field that may be used to carry the S_ID of the original requestor between different servers in the fabric.
Its value in the FC_ACC/FC_FJT frame may be non zero if it was used.
The FCS_Type indicates which FC Service is requested and the FCS_Subtype specifies which server will process the
request. The drive does not check the FCS_Type/FCS_Subtype values returned by the Name Server in the FS_ACC/FS_RJT.
The Options field specifies various options used during FCS processing. The drive sends a value of 0x00, which specifies that
this request must complete before another can be attempted.
The Command/Response Code field identifies specific Fibre Channel Service Information Units (FS_IUs). The Command/
Response Code also determines the type of FS_IU. Command codes are as shown in Table 82.
Table 82: Command/Response Codes
The drive supports only the Command code of 0217h, which specifies a RFT_ID request.
The Maximum/Residual Size field is used by the sender of an FS_REQ to indicate the maximum number of bytes it can
accept in an FS_ACC payload. If the size of the responder’s FS_ACC payload is greater than this value, the responder will
Byte Item
Size
(Bytes)
0
FC_CT 1
1-3
IN_ID
3
4
FCS_Type
1
5
FCS_Subtype
1
6
Options
1
7
Reserved
1
8-9
Command/Response Code
2
10-11
Maximum/Residual Size
2
12
Reserved
1
13
Reason Code
1
14
Reason Code Explanation
1
15
Vendor Unique
1
Value
Description
0000h
Non-(FS_IU)
0001h - 7FFFh
Fibre Channel Service Requests (FS_REQ)
8001h
Fibre Channel Service Reject (FS_RJT)
8002h
Fibre Channel Service Accept (FS_ACC)
other values
Reserved