HP 2000CP 2500CP - Manual (Page 90)

4-4 Service Tests HP DesignJet CP Series Printers
8 Sensors
' page 4-20
The purpose of this test is to verify the operation of the following
Sensors:
D Window Sensor.
D Right Door Sensor.
D Left Door Sensor.
D Refill Valve Sensors.
D Standby Button Sensor.
D Media Sensor.
D Pincharm Sensor.
9 MIO Presence
' page 4-23
The purpose of this test is to verify the presence of the MIO Card and the
communication between the MIO Card and Main PCA.
10 Cutter
' page 4-24
The purpose of this test is to verify the operation of the cutter Assembly.
11 Bail
' page 4-25
The purpose of this test is to verify the operation of the bail stepper
motor.
12 Image Quality
' page 4-26
The purpose of this test is to verify the image quality attributes of the
printer.
13 Printhead ID
' page 4-28
The purpose of this test is to check the printhead ID.
14 Printhead Continuity
' page 4-29
The purpose of this test is to display the primitives and address maps of
the printheads.
15 Clean Roller
' page 4-31
The purpose of this test is to enable you to rotate the Drive Roller when
it requires cleaning.
16 Erase EEROM
' page 4-32
The purpose of this test is to clear the EEROM.
17 Reset Counters
' page 4-33
The purpose of this test is to reset the internal counters.
18 Not Applicable
19 Hard Disk Drive Revision
' page 4-34