HP 2000CP 2500CP - Manual (Page 123)

5-2 Service Calibrations HP DesignJet CP Series Printers
Calibrations
The Printer has several calibration procedures that must be performed
under certain conditions. Refer to the table below to determine when
calibrations are required.
REMEMBER THAT CERTAIN CALIBRATIONS ARE REQUIRED
EVEN IF AN ASSEMBLY HAS BEEN DISASSEMBLED TO GAIN
ACCESS TO ANOTHER ASSEMBLY OR COMPONENT.
When Re uired
Calibrations To Be Done
When Required C01 C02 C03 C05 C06 C07 C08 C09 C10
Electronics Module is
replaced Yes Yes Yes Yes Yes Yes Yes Yes Yes
Carriage is disassembled or
replaced Yes Yes Yes Yes Yes Yes Yes No No
Refill Assembly is
disassembled or replaced No Yes No Yes No Yes No No No
X-axis Assembly is
disassembled or replaced No No No No No No Yes No No
Drive Roller is
disassembled or replaced No No No No No No Yes No No
Banding Problem No No Yes Yes Yes No Yes No No
Edge Detect Problem No No Yes No No No No No No
Misalignment between
Colors No No Yes Yes Yes No Yes No No
Color Accuracy Problem No No Yes No No Yes No No No
Nozzles Out or Misdirected No No No No Yes No No No No