HP 2000CP 2500CP - Manual (Page 64)

System Error Codes 2-29 HP DesignJet CP Series Printers
System Error: 060000
Problem Description: The Line Sensor is not functioning properly because
there is too much ambient light.
Corrective Action: Try the following:
D Close the Window if it is open.
D Move the printer to a location with less light.
The Printer MUST be kept away from direct
intense sunlight or a spotlight.
D Replace the Trailing Cable ' Page 8-36.
D Replace the Carriage Assembly ' Page 8-42.
D Replace the Electronics Module ' page 8-6.
Only replace one component at a time and
check if the error has gone before
replacing another component. Using this
procedure you will be able to determine
exactly which component failed.
System Error: 060100
Problem Description: Incorrect Line Sensor type in the EEROM.
Corrective Action: Try the following:
D Calibrate the Line Sensor ' page 5-10.
D Clear the EEROM ' page 4-32 and perform all
the calibrations again.
D Replace the Electronics Module ' page 8-6 and
perform all the calibrations again.
System Error: 060200
Problem Description: Incompatible Firmware and Carriage PCA.
Corrective Action: Upgrade the Firmware.